Resultado de búsqueda
Bus current draw, max. 40 mA @ 5V DC, 165 mA @ 24V DC. Full scale analog ranges. Voltage: 0...10.5V DC, Current: 0...21 mA. Repeatability. -0.12 to 0.12%. Input and output group to system isolation. 30V AC/30V DC rated working voltage (IEC Class 2 reinforced insulation) type test: 500V AC or 707V DC for 1 minute.
- 1762 MicroLogix Expansion I/O Technical Documentation ...
Quickly access technical specifications, installation...
- Cut Sheet 1762-OF4
1762 MicroLogix 1200 System. 1762-OF4. 1762 MicroLogix 1200...
- 1762 MicroLogix Expansion I/O Technical Documentation ...
- Important User Information
- Additional Resources
- Wire Size and Terminal Screw Torque
- Labeling the Terminals
- Configuration Data File
- Bit 15 and Bits 7...0 - Reserved
- Certifications
- New Product Satisfaction Return
Solid state equipment has operational characteristics differing from those of electromechanical equipment. Safety Guidelines for the Application, Installation and Maintenance of Solid State Controls (Publication SGI-1.1 available from your local Rockwell Automation sales office or online at http://literature.rockwellautomation.com) describes some i...
If you would like a manual, you can: download a free electronic version from the Internet: http://literature.rockwellautomation.com purchase a printed manual by contacting your local Allen-Bradley distributor or Rockwell Automation representative
Each terminal accepts up to two wires with the following restrictions:
A write-on label is provided with the module. Mark the identification of each terminal with permanent ink, and slide the label back into the door.
The configuration of the format for analog outputs is made at going to run (GTR). Changes made to the configuration file while in run mode have no effect on the outputs. The configuration table for analog outputs is shown in the Configuration Data File table.
These bits are reserved and are not checked by the module.
(1) See the Product Certification link at http://www.rockwellautomation.com/products/certification for Declaration of Conformity, Certificates, and other certification details. Notes: Notes: Rockwell Automation Support Rockwell Automation provides technical information on the Web to assist you in using its products. At http://www.rockwellautomation...
Rockwell Automation tests all of its products to ensure that they are fully operational when shipped from the manufacturing facility. However, if your product is not functioning and needs to be returned, follow these procedures.
- 907KB
- 24
Compre Módulo E/S para PLC Allen Bradley 1762, para usar con Serie MicroLogix 1100 tipo Analógico, 1 salida 1762-OF4 Accesorios para Controladores y Autómatas en RS Online y disfrute de una entrega en 24 h, un excelente servicio y el mejor precio del distribuidor líder en componentes electrónicos.
- Allen Bradley
- 1
The 1762 input module is suitable for use in an industrial environment when installed in accordance with these instructions. Specifically, this equipment is intended for use in clean, dry environments (Pollution degree 2(1)) and to circuits not exceeding Over Voltage Category II(2) (IEC 60664-1)(3). Install your module using these installation ...
- 1MB
- 24
MicroLogix 1200 controllers support the DF1 Full-duplex protocol via RS-232 connection to external devices, such as computers, or other controllers that support DF1 Full-duplex. DF1 is an open protocol. See the DF1 Protocol and Command Set Reference Manual, publication 1770-RM516, for more information.
