Resultado de búsqueda
25 de jun. de 2020 · This includes the use of floating IP addresses or broadcast traffic and that influences the implementation of HA architectures. Due to such limitations in Azure, normal FTD High Availability (HA) and clustering setups are not possible, instead, Load Balancers (LB) can be utilized in a certain way to achieve an HA architecture within a VNet.
Initial login on a new or newly-restored-to-factory-defaults FMC now presents the admin user with an Initial Configuration Wizard documented in the Cisco Firepower Management Center Getting Started Guide for FMC models that support Version 6.5.
21 de dic. de 2018 · 12-23-2018 04:13 AM. Note that ASA on Firepower 2100 series only has Management and Eth1/2 and 1/2 interfaces enabled by default. If you want more (for HA reason or anything else) you will need to assign and enable them from Firepower Chassis Manager first. 5 Helpful.
During threat defense high availability creation using the management center or the device manager, all the existing configurations on the selected secondary threat defense unit are replaced with the configuration replicated from the selected primary threat defense unit, so select your primary unit carefully during high availability (HA) creation.
When you break HA, the configuration is erased. Thus, you have the option to resume HA on a suspended system, which enables the existing configuration and makes the two devices function as a failover pair again.
20 de dic. de 2017 · The Firepower appliances running FTD there is no Active/Active HA per se since that was a construct from ASA software that relied on multiple contexts. Straight HA on FTD uses an Active/Standby scheme. You can run a 2-unit cluster which is sort of like Active-Active but very few customers bother to do that. In any case, separate licenses (IPS ...
4 de jul. de 2019 · Is there a way to configure High Availability with another 2100 in FirePOWER Device Management? I know how to do it in FMC, but for this client it has to be on box. Both devices have two interfaces linking each other. I cannot find anything in the GUI to even get started with configuring HA. Is it possible to configure HA in FDM?
