Resultado de búsqueda
15 de may. de 2024 · AL-6XN is low carbon, nitrogen bearing super austenitic stainless steel. The alloy was designed to be a seawater resistant material and has been found to be resistant to a broad range of corrosive environments.
Hace 2 días · berAlweld ® M1070 is an AlSi filler metal for MIG and TIG welding of pure and mostly pure aluminium. Features: Good fluidity; Typical Base Materials: Pure aluminum; Mostly pure aluminium (max. 0.5% of alloying elements) Typical applications: Chemical industry; Construction industry; Electronics; Food industry; Standards: DIN EN ISO ...
25 de abr. de 2024 · Filler metal selection. Al and Fe contribute to mechanical properties, while Ni, Cu, and Ti enhance microstructural and corrosion properties. The elemental wires, with 99.99% purity and 0.6 mm diameter, were meticulously chosen.
Hace 3 días · Aluminium alloy. An aluminium alloy ( UK / IUPAC) or aluminum alloy ( NA; see spelling differences) is an alloy in which aluminium (Al) is the predominant metal. The typical alloying elements are copper, magnesium, manganese, silicon, tin, nickel and zinc. There are two principal classifications, namely casting alloys and wrought alloys, both ...
15 de may. de 2024 · The results show that the addition of 1%B enhances significantly the wettability of Mo-45Ni filler metal. The strength of the brazed joint with Mo-45Ni-1B filler metal is 30% higher than that of the joint with Mo-45Ni filler metal.
29 de abr. de 2024 · Furthermore, ultrasonic scanning results reveal that the Sn additive effectively eliminates voids to 0% at the interface due to increased fluidity of the Ag–Cu–Ti–(Snx) filler and also improves the wettability of the modified filler to the AlN ceramic substrate.
In the case of dissimilar welding between AISI 1020 and AISI 304L thin sheets without filler metal , Scutelnico et al. documented the formation of a hard, martensitic microstructure in the WZ, as shown in Figure 8 by the results of Vickers hardness measurements, performed along a traverse on the joint cross-section from the CS-side (AISI 1020 mild steel side) to the SS-side (AISI 304L ...
